Yes this is a blatant rip-off of PartDaddy's HE280 Whip Clip. It's definitely not as pretty but its easier to print. No supports needed and fast to print. Also the forces on the clip are in or along the layers as opposed to across layers. This means the clip shouldn't break as easily when installing. Of course since it is in three parts it takes a bit of dexterity to install. IGES format included in case you need to adjust lengths for your particular whip.
--Created this to check bed calibration. --Model walls are 1 mm wide. --Model is 1 mm tall. --280 mm dia. outside (white line on Onyx bed). --Small arrow in center points to front of machine. --Drawn in Fusion 360.
These FSR mounts are designed for use in aluminum, and were produced and anodized by Matt at 713Maker.com. The printed prototypes work, but are prone to tearing out the threads internally. Thread is a 4x40 to match the originally shipped parts from the Rostock max V2.
As the title says, it's a Duet mount for the Rostock Max V2 that can replace the stock mount. It can take up to two 60MM fans for cooling. I've designed it primarily for laser cutting, however an STL is provided (Untested so far), for those who don't have access to a laser cutter.
This bracket attaches a 60mm angel eye LED ring to the bottom of the new Rostock Max V2 ball cup platform. Also needed to modify the layer fan shroud from jjjohnson, http://repables.com/r/621/ , to make room for the bracket and LED ring. http://repables.com/r/621/
It's a tight fit, but it will go over the wire loop, and screw in with the provided screws. As usual for me, both original and Netfabbed STL's are available. Has been tested (only a little so far), and uses the clip geometry from Dan's design. (http://repables.com/r/708/ ). A concern is that it seems to hold it fairly loosely. I may add a little pillar for a second clip location. Edit: Version 2 is no longer available, as I messed up somewhat. Please accept my apologies if you've already printed it. V3 should fix most of the issues. http://repables.com/r/708/
Spool Holder for Rostock MAX v2 I've seen a lot of designs out there, but I couldn't find anything that was perfect for me, so I designed this one. It has three spacers included to align the center of the Spool of Filament perfectly over the exit hole in the top of a Rostock MAX v2 using SeeMeCNC Filaments. Other spools should work just the same as they pretty much all use the same spool dimensions... Usually.
* UPDATE: Added .3ds file so you can muck around with the file :) * UPDATE: Included version with 10mm shorter legs to allow it to work with Rostock layer fan. Nozzle sits ~24mm below the effector with this version. * UPDATE: I increased the lower plate thickness to 6mm to match the e3d better. Also added separated files for those who want to tweak :) This mount puts the e3d nozzle ~12mm below the effector plate. Sorry about the extra files, but I can't delete the old ones for some reason :/