*Voronoi Pearl Light **Lamp No. 1 *for LED-Spots or LED tealight candle*Small lamp > big impact! * This Voronoi *Pearl Light Lamp* is a beautiful decoration and lamp. Through the voronoi-parts, the light casts a beautiful light and shadow effect. The Voronoi Pearl Lamp looks so at day and night very nice and is therefore ideally suited as a gift and decoration. *Original size: *Ca. 10.4 x 10.4 x 6.8 cm The Lamp is composed of two parts (shells) which are set on each other. Simply inserting an LED tea light candle or a other LED-light in the inside of the bottom part. In the photos, we use as lighting for example the cheapest LED spot of IKEA ("LEDBERG" LED spot) and the light is impressive.*Important: *Please use only LED lights. Do not use real tea lights. *Printing: *Printed with black PLA. Without support. More lamps and candleholder etc. in different sizes and shapes can be found here:www.shapeways.com/shops/designgravity  https://www.shapeways.com/shops/designgravity?s=0&section=-+Candleholder+%26+Lamps
This uses a battery powered LED flashlight available at most hardware stores to create a Steampunk Accent table top lamp. Printed in white and translucent PLA at .4 resolution. It would finish off nicer at .3 or .2 if you like a smoother finish. Also needed is a couple of small pieces of 11/64 or 18 mm wood trim stained or not. The LED’s bounce off of the printed reflector in the shade. The shade is one interlocking piece printed x4. I changed filament after the first 4 layers on some of the shade pieces to providing highlights. Prints with minimal supports and I have included supported files for those needing it.