This vase is made in two pieces, One is the vase and the bottom part is the support and water collector. You can take off it in a very easy way, just sliding it up. You can also choose between 2 differents support.In the first one you will see the continuity of the vase to the support and water collector, in the second one as you can see in the images, will be a 5 mm of space between the parts.
This is just a simple vase with a nice twisted design that would actually hold flowers and anything like that. Hex-Twist Vase  by JoshGene  is licensed under theCreative Commons - Attribution - Share Alike license. http://www.thingiverse.com/thing:715728 http://www.thingiverse.com/JoshGene http://creativecommons.org/licenses/by-sa/3.0/
PLActron vase deltayoumagine.com
the design of this vase is based upon a custom made guitar pick/plectron (PLActron - the customizable & biodegradeable guitpick), which is rotated 240 degrees around the z-axis an extruded along a sine in z.this model is scaled to be printed with 20cm height,which should fit /most printers/ and /most flowers/.you can download not one, but 3 different versions of this vase.while the smallest with 32 segments adds some interesting geometry, the 500seg is the way to go if you want a smooth shape,if you can't decide take the 100seg-versionslicing suggestions for Cura 15.02.1Standard configPrint Speed: *42mm/s* yes, this is essentialLayer Height: 0.1 mmShell Thickness: 0.8mmRetraction offBottom/Top Thickness 1.1mmFill Density: 0%No Support, No Platform adhesionExpert config;Section Infill: uncheck "Solid infill top"Section Black Magic: check "Spiralize the outer contour"this model is quite easy to print, no overhangs and no detailed structures, you could print it in 0.3mm > Layers without much hesitation.
To make a vase, print with several bottom layers, two walls, and no top layers.Blender seemed to have trouble with the STL export of this. As a result, you'll need to scale it up a fair bit in your slicing program. I used Slic3r and from memory it needed 1000% scaling. It printed fine.
PET VASE CAP_03_slitredpah.com
PET VASE CAP_03_slit is VASE CAP that can be attached to the PET bottles for carbonated. (It depends on the type of plastic bottles.) Easily I enjoy the up cycle!Output of the future 3D printer in the same way as the PET bottles also I am hoping to put out the recycling.Of support under the screw portion Please remove after output.About size 77x66x61 mm