Arduino 3D model for printing: 236 results found
Displaying 1 - 10 of 236
======== SUMMARY =============================================================a simple case for an arduino Leonardo, that features a cover for a nokia LCD 5110 and joystick shield v2.4 from elecfreaks. There are also buttons for the F/E small buttons and a big button for the also tiny reset button. If there are any problems with this case let me...
239 downloads28 views
======== SUMMARY =============================================================Case for Arduino Mega R3 and RAMPS 1.4 (for Prusa i3 or other).80mm/140mm/63mmFor printing side by side!Use nut M3 and bolt 8 or 10mmBe careful when you insert nuts, must be on the right position otherwise you risk to break the plastic.Hi hope nuts you have will fit well...
7.7K downloads32 views
======== SUMMARY =============================================================This project is ongoing. Updates will be listed below, with the most recent at the top.UPDATE 2: We've added an ultrasonic sensor adapter for the rail system. Be sure to carefully fit the sensor in the first few times. Afterwards, it should slide in perfectly.UPDATE...
441 downloads30 views
======== SUMMARY =============================================================This thing contains a mounting plate and a drilling guide for the “Arduino UNO / Duemilanove / Diecimila / Leonardo / NG / Extreme”.The plates are not symmetrical. The notch shall be on the power jack and ethernet cable side. The base plate is 2 mm thick. M2 5 mm or 1/4...
283 downloads41 views
Housing for Arduino Leonardo compatible evaluation board with WiFi/Bluetooth module "radino Leonardo"
======== SUMMARY =============================================================This is a Housing for an Arduino Leonardo compatible evaluation board for "radino" radio modules with integrated WiFi or Bluetooth called "radino Leonardo".The "radino Leonardo" is available here: http://shop.in-circuit.de/product_info.php?...
324 downloads41 views
======== SUMMARY =============================================================Arduino mount needing just one screw to hold the board. For UNO type boards. Will screw to Actobotics channel or most other chassis/surfaces.======== PRINT SETTINGS ======================================================*Rafts: * Doesn't Matter*Supports: * Doesn...
41 downloads19 views