Prusa 3D model for printing: 407 results found
Displaying 1 - 10 of 407
This file was created with Autodesk Inventor 2016Cura 15.02.1 was then used as slicing softwareThe Dimensions of the holes are shown above in the sketch:2xM81xM10All holes have a TIGHT FIT!...so that the construction doesn´t wobble.The dimensions in the sketch shown in the picture are in [mm].Here are the parameters for 3D printing this part:-...
3 downloads48 views
Spool support without ball bearings, they are not indispensable ;-)
257 downloads50 views
======== SUMMARY =============================================================Hi Guys,I have my Prusa Air 2 Remix uploaded. It is currently not ready yet so please do not be surprised if I do change something. Preliminary a thank you to the other who the Prusa Air 2 designed and improved. I've taken a few components, make it easier to print...
1K downloads49 views
======== SUMMARY =============================================================This part allows me to replace the stepper by a DC motor with encoder without removing the old part, just loose a couple of nuts and slide it in.Two M3 screws will keep old part (blue) and new one (orange) together so belt tension will not pull the part out.The orange...
217 downloads28 views
======== SUMMARY =============================================================Prusa Mendel i2Taken from http://reprap.org/wiki/Prusa_Mendel_%28iteration_2%29#Printed_Parts It contains 4 plates with all parts, including Greg's Extruder.======== INSTRUCTIONS ========================================================Print each of the 4 plates...
805 downloads47 views
======== SUMMARY =============================================================This is designed for the extruder head of my prusa i3 (your milage may vary). The 2 mounting screws are ~M3 (3mm diameter) and 30mm apart. The holes for the 4 clamps are also M3..Fits 60mm circumference markers and 25mm circumference pens.
184 downloads35 views
======== SUMMARY =============================================================If you have a Prusa i3 and are upgrading your hotend to an E3D v6 with Bowden, then you'll need this hotend mount for your X-carriage.As this design clamps the hotend to the mount, there's no chance of a wobbly hotend.https://www.youtube.com/watch?v=rSiWot9tib8...
17.1K downloads36 views